Check/Fill Hydraulic Oil Level - Ferris Voyager FS5250 Series Operator's Manual

34
Work Functions:
Callout
A Battery Ignition
B Brake Switch
C Platter
D Shaker
E Headlight
F Kill
G Platter
H Shaker
Auxiliary Functions:
Note: The auxiliary functions are not included with the
machine. The machine is equipped with auxiliary fuses for
optional add-on functions.
Callout
I Auxiliary 1 Fuse
J Auxiliary 2 Fuse
K Auxiliary 3 Fuse
L Auxiliary 1 Relay
M Auxiliary 2 Relay
N Auxiliary 3 Relay
Starter / Engine / Pump:
Callout
O Pump Relay
P Pump
30
Function Amperage
20 amp
3 amp
10 amp
10 amp
5 amp
N/A
N/A
N/A
Function Amperage
5 amp
5 amp
5 amp
N/A
N/A
N/A
Function Amperage
N/A
40 amp
Callout
Q Spreader Motor
Controller

Check/Fill Hydraulic Oil Level

Oil Type: Parker HT-1000 hydraulic oil or equivalent.
This unit is equipped with one hydraulic oil tank. This
hydraulic oil tank provides oil to the two wheel motors and
the pump. The level of oil in the hydraulic oil tank must be
checked, and if necessary, filled.
35
1. Locate the hydraulic oil tank. The hydraulic oil tank is
located on the right side of the unit (A, Figure 35).
2. Check the oil level when the unit is cold. The oil should be
up to the "FULL COLD" mark (B) on the hydraulic oil tank.
If the oil is below this level, proceed to step #3.
3. Before removing the tank cap, make sure that the area
around the tank cap and fill neck of the tank is free of
dust, dirt, and other debris. Remove the tank cap.
4. Add oil up to the "FULL COLD" mark.
5. Install the tank cap.
6. After adding oil to the tank, it may be necessary to purge
air from the hydraulic system. To purge air from the
hydraulic system, simply drive the machine.
Function Amperage
20 amp
ferrismowers.com