Spreader Control Functions And Locations - Ferris Voyager FS5250 Series Operator's Manual

10
• To release the spray boom, open the spring latch.
• To close the spray boom, fold the boom towards the
spring latch and ensure the spring latch closes over the
pin on the end of the boom.
Liquid Material Tank Selector Lever
This lever controls which tank from which liquid fertilizer will
be drawn. The left, right, or both tanks can be selected. Move
the lever to the position of the desired tank(s).
Spray System Pressure Gauge
This gauge displays the pressure of the spraying system
to the operator. To adjust the spray system pressure, see
the Spray Pressure Adjustment Control
Spray Pressure Adjustment Control
This knob adjusts the pressure of the liquid material spray
system. To adjust, turn the knob left or right.
• Turn the knob to clockwise to increase the pressure.
• Turn the knob counter-clockwise to decrease the
pressure.
Boom Control Levers/Spray Toggle Valves
These levers control the boom sections. There are left, right,
and center boom sections. Each boom section contains two
sprayers. The boom sections can be used simultaneously or
separately depending on spraying needs.
• To turn activate the sprayers in a boom section, pull its
lever to the ON position.
• To turn deactivate the sprayers in a boom section, push
its lever to the OFF position.
Spray Pump On/Off Switch
This switch (A, Figure 11) activates the sprayer pump.
14
11
• Press the switch to the ON position to start the sprayer
pump.
• Press the switch to the OFF position to stop the sprayer
pump.
See Operating the Sprayer for additional instructions.
Spreader Control Functions and
Locations
The information below briefly describes the function of
individual controls. Spreading requires the combined use of
several controls applied in specific sequences. To learn what
combination and sequence of controls to use for various tasks
see the Operation section.
ferrismowers.com