Ferris Voyager FS5250 Series Operator's Manual page 12

Hour Meter
This unit is equipped with an hour meter that records the
number of hours that the engine has run. The hour meter also
reports the engine RPM. Press the button (A, Figure 6) on the
hour meter to switch between the two outputs.
6
Ignition Switch
The ignition switch starts and stops the engine, it has three
positions:
OFF: Stops the engine and shuts off the electrical
system.
RUN: Allows the engine to run and powers the electrical
system.
START: Cranks the engine for starting.
Note: Never leave the ignition switch in the RUN position with
the engine stopped—this drains the battery.
Fuel Tank Cap
To remove the fuel tank cap, turn counter-clockwise.
Steering Control Levers
This unit is equipped with a maximum forward speed control
bar (A, Figure 7) which is located in front of the forward speed
control levers.
12
7
A. Maximum Forward Speed Control Bar
B. Left Ground Speed Control Lever
C. Right Ground Speed Control Lever
D. Cam Lever
E. Rear Stationary Lever
The maximum forward speed control bar can be adjusted in
any position within its positioning slot. The closer the control
bar is to the ground speed control levers (B & C) the slower
the unit will drive and the further away from the ground speed
control levers the faster the unit will drive.
To adjust the position of the maximum forward speed control
bar release the cam lever (D), position the control bar in the
desired location, and then lock the cam lever back in place.
You should only adjust the position of the maximum forward
speed control bar after you have stopped all movement of the
unit.
This unit is equipped with a left ground speed control lever
(B) and a right ground speed control lever (C). These levers
control the ground speed and direction that the unit travels
in. The left lever controls the left rear drive wheel and the right
lever controls the right drive wheel.
FAST FORWARD
SLOW FORWARD
NEUTRAL
REVERSE
ferrismowers.com