Mounting And Elongating The Extension Auger - Janfire NH Installation And Servicing Instructions

4.3 Mounting and Elongating the Extension Auger

1. Mount the auger according to Figure 7 Auger attachment
ins M8x30
M6x30
M6x16
Figure 7 Auger attachment
NOTE: The more compact part of the auger should always be mounted at the end of the external auger.
NOTE: In no circumstances shall a vacuum feed pellet delivery system be installed to the burner.
2. Adjust suspension chain of external auger so that auger outlet is only slightly offset above the internal
hopper of burner with burner in place (see Figure 5. Function description). Make sure the burner drop
tube is nearly vertical.
NOTE: Ensure secure mounting to avoid risk for the auger to fall.
3. To maximize emptying of the external pellet storage, the inlet of the auger should be placed as centrally
in the storage bin as possible.
4. Connect the 3-wire cord contact from the burner to the corresponding terminals on the external motor
(See Fig. 15 for wiring instructions). Check proper rotating direction of feeding auger; refer to auger
motor wiring for rotation reversal.
NOTE: Do not touch the dosage auger or the external augers in or outlet openings when the external
feeding motor is connected.
Fasten the drop tube to the external auger outlet and to the burner hopper inlet with the supplied hose clamps,
use a little soapy liquid on the inside of the tube to ease the sliding. Avoid sharp bends or slack in the drop tube
that can cause a blockage in the external auger. Cut off excess length with a sharp knife.
Janfire NH Burner Service Installation Manual 4.16.09 - Technical specifications are subject to change without prior
notice.
insex M8x30
M8x30
)
14(38