Using The Self-Cleaning Cycle - Whirlpool RF395LXE Use & Care Manual

S
ETTING THE CONTROLS
NOTE: Make sure the clock is set to the correct time
of day. (See "Setting the clock" in the "Using Your
Range" section.)
To start cleaning immediately:
1.
Press the auto clean pad.
This will automatically set a 3
Self-Cleaning cycle.
NOTE: There will be a 30-minute cool-down
1 ⁄ hour before the cycle is over.
2
2.
Set the cleaning time (optional).
If you want a Self-Cleaning cycle longer or
shorter than 3 1 ⁄ hours, use the hour and minute
2
pads to set the cleaning time you want. Press
the "up" (s) or "down" (t) pad(s) until a time
1 1
between 2 ⁄ -4 ⁄ hours shows on the display.
2 2
•
Use 2 1 ⁄ hours for light soil.
2
•
Use 3 1 ⁄ -4 1 ⁄ hours for average to heavy soil.
2 2
3.
Start the oven.
Make sure the door is closed all the way. If the
door is open even a little, it will not lock. Press
the door closed if needed. If the door is closed, it
will lock as soon as you press the start/enter pad.
4.
After the Self-Cleaning cycle ends:
LOCKED goes off and the door unlocks.
5.
After the oven cools to room temperature, wipe
off any residue or ash with a damp cloth or
sponge.
If needed, touch up spots with a mild abrasive
cleanser or cleaning sponge.
PRESS
1 ⁄ -hour
2
AUTO
CLEAN
PRESS
PRESS
START
ENTER

USING THE SELF-CLEANING CYCLE

YOU SEE
YOU SEE
HR MIN
(example shows 4
cleaning time)
YOU SEE
HEAT
5 SEC TIME D
YOU SEE
CLEAN
TIME
CLEAN
TIME
1 ⁄ -hour
2
ON
LOCKED CLEAN
TIME
CLEAN
continued on next page
31