5. Before turning machine off, let it run at full RPM a few minutes to make sure that all material
has been discharged.
6. When machine is new or when putting on a new belt: apply a finger full of grease to the
underside of belt. Be sure engine is off. NEVER REACH INTO BELT AREA OR
BEHIND BELT GUARD WHILE ENGINE IS RUNNING.
NEVER REACH INTO, OR LOOK INTO CHUTES OR HOPPER FOR ANY REASON
WHILE PERFORMING MAINTENANCE OR REPAIR, ALWAYS REMOVE KEY
O:\Manuals\625NS CHIPPER.SHREDDER.VAC\625NS P.W. 10.16.2009.doc
OPERATING INSTRUCTIONS
(Continued)
SALSCO CHIPPER / SHREDDER / VAC
WHILE RUNNING MACHINE.
FROM ENGINE. ENGINE IS IN NEUTRAL.
- 10 -