Assembly Threaded Adapter - Harken REFLEX FURLING Unit 1 Installation Manual

Assembly Threaded Adapter
Thread the adapter completely into the
drive unit until it stops.
Back the adapter out no more than one (1)
rotation until the set screw holes line up
with the recesses at the top of the threaded
adapter. Sight into one of the set screw
holes to confirm alignment.
IMPORTANT! Make sure the adapter is
either parallel or perpendicular to the
feeder opening.
The parallel or perpendicular position
will depend on the fitting on the bow
sprit or extended bow fitting.
Install set screws using threadlocking
solution such as blue Loctite adhesive.
®
2:1 soft attach threaded adapter installs
the same way as above. Tip: Load the
loop or 2:1 adjuster in the adapter before
installing.
Tip: The D-shackle adapter and snap
shackle adapters use the same threaded
bases so you can switch the shackles to
change types.
8 Loctite is a registered trademark of Henkel AG & Company KGaA.
Reflex furler