Frame Assembly Instructions - Reverie POWER-FLEX 3 Owner's Manual And Reference Manual

POWER-FLEX 3
IMPORTANT UNPACKING INSTRUCTIONS
To avoid damage to the Adjustable Base,
always open the carton while the Adjustable
Base is laying in the FLAT position on the
floor.
OPEN FLAT
STEP 1
Carefully lift the Adjustable Base unit out
of the shipping carton, keeping the unit
top side down. For safety reasons, this
should be performed by 2 people.
STEP 2
Assembling Adjustable Base legs: Open the
accessories box, take out the 4 legs,
and thread them in a clockwise direction into
the threaded holes in the frame.
NOTE: Tighten the legs securely to the frame.
Leave no space between the leg and frame.
™
Extend the power cord from the frame.
Remove the plastic packaging from the
Adjustable Base.
Carefully rotate the Adjustable Base
over the topside up position.
Plug the power cord into a grounded electrical
outlet.
Install the batteries in your wireless remote
wireless remote control to verify that all of
the features are operational. If your
Power-Flex™ 3 Adjustable Base does
NOT operate, please refer to the
Troubleshooting section beginning on
page 25 of this manual.
CUSTOMER SERVICE: 800-973-8374
SERVICE@POWERFLEXBASE.COM
10

Frame Assembly Instructions

STEP 3
WARNING:
POWER CORDS MUST NOT INTERFERE
WITH ANY Adjustable Base MECHANISMS.
STEP 4
STEP 5
ATTENTION!
DO NOT
lean the Adjustable
Base against the
installed legs to flip
it over.
STEP 6
NOTE: An electrical surge protection unit is
recommended (not included)
STEP 7
Improper handling