Whirlpool RF365PXX Use And Care Manual page 17

Replacing
Burn, Electrical Shock and Fire Hazard
l
Make sure all surface units are OFF before replaclng surface units and
burns or electrical shock.
l
Do not line the reflector bowls with foil. Fire or electrical shock
1.
Turn off all surface units.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
2. Line up openings in the reflector
bowl and notches in the trim ring
with the surface unit receptacle
and the element hold down clip.
4. When terminal is pushed into the
receptacle as far as it will go, push i
down the edge of the surface unit
opposite the receptacle. The ele-
1
ment hold down clip will keep the
i
surface unit from moving around.
f
;
NOTE: Reflector bowls reflect heat back to the utensils on the surface
units. They also help catch spills. When they are kept clean, they reflect
heat better and look new longer.
If a trim ring gets discolored, some of the utensils may not be flat
i
enough, or some may be too large for the surface unit. In either case,
some of the heat that's meant to go into or around a utensil goes down
and heats the trlm ring. This extra heat can discolor it. See Cooking
A--lA- .--d_.---%-l---- ~~~~~~
1