Related Manuals for EcoloxTech 240
Summary of Contents for EcoloxTech 240
- Page 1 OPERATION MANUAL EcoloxTech 240 System EcoloxTech Tel. +1 954-900-6070 service@ecoloxtech.com Last Update: May 1, 2020...
-
Page 2: Table Of Contents
Table of Contents Specifications Page 3 Requirements Page 3 Buttons and Display Page 4 Operational Modes Page 4 Settings & Performance Page 5 System Alarms Page 5 Safety Precautions Page 6 Additive Formulas Page 6 Changing Additive Page 7 Controlling Concentration Page 7 Measuring Concentration Page 10... -
Page 3: Specifications
Specifications Model EcoloxTech 240 Power AC 110/220V 50/60HZ 180W Dimensions 32 x 17 x 42 cm (12.5 x 6.5 x 16.5 in) Weight 11.8 kg (26 lbs.) Production Cell Type Single cell electrolysis for generating hypochlorous acid (HOCl) Concentration Range... -
Page 4: Buttons And Display
Buttons and Display Description LED display System is running Check error code in LED display System RUN On/Off Mode button (see uses below) Set button (see uses below) Reset alarm to resume running Operational Modes The standard mode is the default and should be used unless connecting system to a Standard Mode holding tank with a float sensor. -
Page 5: Settings & Performance
Settings & Performance Flow Rate measured in The flow rate can be controlled by tightening or loosening the inflow water valve. A higher flow rate will decrease the concentration of free available chlorine (FAC) and a Liters per minute (L) lower flow rate will increase the concentration of FAC. -
Page 6: Safety Precautions
Safety Precautions Brine / Additive Formulas Electrolyzed water contains small quantities of hydrogen gas (H2), chlorine dioxide gas (ClO2), and ozone gas (O3) that is released from solution into the air. These gases, if accumulated, can be explosive. Electrolyzed water contains free chlorine molecules. Free chlorine molecules have the potential to form chlorine gas (Cl2) when the pH of Ventilation Risks the solution becomes acidic. -
Page 7: Changing Additive
Changing Additive Replenish additive tank when low. If additive runs out, the system will stop and display Error 2. Changing Additive Using Formula #1 • Power Off system • Remove suction line and cap from additive tank • Add 2 cups of salt to additive tank •... - Page 8 Using Additive Formula 1 (Water and Food Grade Salt) Flow Rate 3.5 - 5.0 L/min Lowering the flow rate will increase the ppm. 17.5 A 22.0 A Pump Speed (PS) Raising the flow rate will decrease the ppm. 10 PS 42 ppm 49 ppm 43 ppm...
- Page 9 Using Additive Formula 3 (Water, Food Grade Salt, and HCl) Flow Rate 1.0 - 1.5 L/min Lowering the flow rate will increase the ppm. 17.5 A 22.0 A Pump Speed (PS) Raising the flow rate will decrease the ppm. 139 ppm 163 ppm 10 PS 144 ppm...
-
Page 10: Measuring Concentration
For greater accuracy or to measure high range free available chlorine levels, the chlorine concentration can be measured with a high range chlorine photometer. Supplies for measuring free chlorine concentration can be found at: Store.EcoloxTech.com and search SKU listed below. Chlorine Test Paper (SKU: P-1050)