Specifications Model EcoloxTech 240 Warewash Power AC100/220V 50/60HZ 180W Dimensions 32 x 17 x 42 cm (12.5 x 6.5 x 16.5 inches) Weight 11.8 kg (26 lbs.) Production Cell Single cell without a membrane Concentration 0.3% to 0.5% Potassium Hydroxide...
Buttons and Display Description LED display System is running Check error code in LED display System RUN On/Off Mode button (see uses below) Set button (see uses below) Reset alarm to resume running Operational Modes The standard mode must be used when no storage tank has Standard Mode been installed for storing electrolyzed water.
Settings & Performance Liters per Minute (L) The liters per minute is a performance measurement and is not an adjustable setting from within the system. The liters per minute is dependent on the feed water flow into the equipment. A higher feed water flow will decrease the ppm and a lower feed water flow will increase the ppm.
Pump Speed (PS) The pump speed is an adjustable setting. The range is from 0 Max. speed: 0 to 19. Lower settings will increase the pump speed and Min. speed: 19 therefore generate a more concentrated solution of electrolyzed water which can be measured in free available (mg/L or ppm).
• Unscrew cap on new additive bottle and break the seal • Place new additive bottle in system and insert suction line • Power On system and press “Reset” button Warewash Additive (SKU A-1060) can be found at the EcoloxTech Online Store: http://store.ecoloxtech.com...