Advertisement
Table of Contents
Newport Gliders Bearing Replacement Instructions
1.
Remove the base from the chair by
taking out the plugs & screws located on
each side panel (6 plugs & 6 screws in all).
2
8
ITEM
1
Side Panel
2
Bonhomme
3
Bearing
4
Bearing Bolt
5
Locking Nut
6
Bonhomme holder
7
Bonhomme holder screw
8
Truss Screw
2.
Using an impact air wrench with a 6 point socket,
remove nylon locking nuts (#5) located on the inside
of the base (4 on each side). Base may need to be
brought to a local garage or tire center to remove/
replace nylon locking nuts.
5.
Remove the screws
holding the bearing in place.
6.
Re‐attach the nylon locking nut 6 to the bolt
.
Using a type of pry‐bar, gently push down on the bar the bearing bit the bolt will come out of the hole.
.
Using a socket and hammer, lace N W bearing bolt into place.
9.
Replace the screws to hold the bearing into place Repeat process for all bearings , then reassemble the base.
PART NUMBER
3.
able to be removed. Use a screwdriver
to wedge if needed. Remove side
panels from base.
4.
There are two Bonhomme holders (#6), each
having four screws (#7). Only remove two screws
from each one, and on the same side.
in the bearing 3 .
3
4
5
7
The side panels should now be
DETAIL A
1
A
6
2
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Newport Glider
Summary of Contents for Newport Glider
- Page 1 Newport Gliders Bearing Replacement Instructions The side panels should now be Using an impact air wrench with a 6 point socket, Remove the base from the chair by able to be removed. Use a screwdriver remove nylon locking nuts (#5) located on the inside taking out the plugs & screws located on to wedge if needed. Remove side of the base (4 on each side). Base may need to be each side panel (6 plugs & 6 screws in all). panels from base. brought to a local garage or tire center to remove/ replace nylon locking nuts. DETAIL A 4. There are two Bonhomme holders (#6), each having four screws (#7). Only remove two screws from each one, and on the same side. Remove the screws holding the bearing in place. Re‐attach the nylon locking nut 6 to the bolt in the bearing 3 . Using a type of pry‐bar, gently push down on the bar the bearing bit the bolt will come out of the hole. Using a socket and hammer, lace N W bearing bolt into place. Replace the screws to hold the bearing into place Repeat process for all bearings , then reassemble the base. PARTS LIST...
- Page 2 Swivel Bearing Replacement Instructions With chair laying on its back, using a 3/4" wrench or socket, remove 1/2" bolt, lock washer and flat washers (#6,#7 and #8 on Parts list). 1/2" bolt is located on the bottom of hex base. With 1/2 bolt and washers removed, hex base can be pulled off leaving chair attached to swivel bearing seat bracket (#1) First swivel bearing is seated directly beneath 1/2"...
Need help?
Do you have a question about the Glider and is the answer not in the manual?
Questions and answers