8 Setting to work
8.1
Radar scanner initial power on test
With all cables correctly and securely connected, ensure the transceiver power switch is set to ON.
DISPLAY SUB-SYSTEM
The display sub-system must be switched on and commissioned to control the transceiver.
At switch ON, the magnetron warm-up sequence should start, after which the transceiver should enter
Standby mode.
8.2
Radar checks
Before rotating the radar scanner, ensure all personnel are clear.
The radar scanner transmits electromagnetic energy; ensure all personnel are clear of the scanner
1.
From the display sub-system, select the transceiver and place it into run.
2.
Ensure that the system runs and that the antenna rotates.
3.
Test the transceiver functionality across all available ranges.
X-band 12kW Upmast Magnetron Transceiver
Chapter 8: Setting to work
WARNING
RADAR SCANNER SAFETY
WARNING
RADAR TRANSMISSION SAFETY
when the radar is transmitting.
HBK-2300-3 Issue 2
Page 29 of 40