Download Print this page

Jackedin Power Locker JACK Manual

Table of Contents

Download this manual

Locker JACK

Unpacking the Locker JACK

Included:

1 Locker JACK

1 Door Lock Control Key

1 Power Cord

2 90 degree wall mount brackets

4 10-32 x 5/8" screws

Optionally Purchased:

40 Micro USB cords

40 Lighting connector adaptors

For safe and proper installation JackedIn Power recommends installing the Locker JACK as indicated below:

1. Choose a location for the Locker JACK that has a 110 V outlet within 6 feet of the power entry module. Remove the

Control Key that is taped to the back of the unit and store in a safe and secure location outside of the Locker JACK.

2. Install the two 90 degree wall mount brackets as indicated in picture below (See Figure 1) before mounting the

Locker JACK unit to them. Use three (wall material appropriate) lag bolts (1/4" dia x 2" long) per 90 degree wall

mount bracket (6 lag bolts not included with the unit).

Figure 1

Table of Contents

Do you have a question about the Locker JACK and is the answer not in the manual?

Page 1 For safe and proper installation JackedIn Power recommends installing the Locker JACK as indicated below: 1. Choose a location for the Locker JACK that has a 110 V outlet within 6 feet of the power entry module. Remove the Control Key that is taped to the back of the unit and store in a safe and secure location outside of the Locker JACK.
Page 2 Installation (cont) 3. After installing the two 90 degree brackets to the wall, team lift (more than one person) the Locker JACK onto the previously mounted brackets. Line up the four mounting holes on the bottom of the Locker unit with the four bracket holes and install the four 10-32 x 5/8”...
Page 3 5. Lastly, install the included power cord and plug the Locker JACK into the available 110V outlet. Proceed to the next section with respect to opening the Locker JACK for the first time. Unlocking the door for the first time.
Page 4 Daily use of the Locker JACK 1. Enter the required code (Manager or User Code) to open the Locker JACK 2. Use your chosen USB charging cord and plug the USB end into on of the 40 available USB ports and the other end of the cable into your phone.