Juniper EX8200 Installing page 2

Related Topics
Published: 2009-10-08
2
Installing a DC Power Supply in an EX8200 Switch
Using both hands, place the power supply in the power supply slot on the front
8.
of the switch. Slide the power supply straight into the chassis until the power
supply is fully seated in the slot. Ensure the power supply faceplate is flush with
any adjacent power supply faceplates or power supply cover panels.
Push the handle towards the faceplate of the power supply until it is flush against
9.
the faceplate.
Push the captive screw into the power supply faceplate. Ensure that the screw
10.
is seated inside the corresponding hole on the faceplate.
Tighten the captive screw by turning it clockwise using the Phillips (+)
11.
screwdriver, number 1. When the screw is completely tight, the latch locks into
the switch chassis.
To connect power to a DC power supply, see Connecting DC Power to an EX8200
Switch
Figure 1: Installing a DC Power Supply in an EX8200 Switch
Removing a DC Power Supply from an EX8200 Switch
DC Power Supply in an EX8200 Switch