Advertisement
8. Continue pulling Shroud down all around.
Doffing
1. Untie all ties.
2. While pulling up the shroud
6. Loosen Ratchet Knob
(counterclockwise).
10. Connect Charger to mains wall power,
connect the Charger Cord to the Battery.
Push the Charger Cord Connector into the
Battery Receptacle until it is fully seated.
Bio-Medical Devices Intl
Page 4 01023577 Rev B
from the bottom back, roll the
shroud inside-over-outside, up
and over the Helmet.
7. Lift Helmet up,
foreward, and off the
head.
17171 Daimler Street
9. Don outer body gown
under the shoud per
gown manufacturer's
instructions.
3. Continue rolling while bringing
shroud to front, pulling Lens off the
Helmet. Continue pulling foward
away from the body and discard.
8. Disconnect Power Cord from
the Battery - push Secure
Connection Button down,
pull Cord Connector out,
release the Button.
WARNING
Refer to Users Instructions
(P/N 03521015) for details on
chargers and charging batteries.
Irvine, C A 92614
2260-05 DLC Shroud
Instruction For Use
10. Pull neck ties around to the
front and tie securely, leaving
about a ½ inch gap between
neck and Shroud. Pull waist
ties around and tie in front.
4. Remove other PPE
per manufacturers'
recommendations.
5. Discard all
disposables per
institutional
protocal for
contaminated
waste.
9. Disconnect the Battery Belt
from around the waist by un-
snapping the buckle.
The entire CAPR System may be
decontaminated, cleaned and/
or stored at this time.
800-443-3842
www .maxair-systems.com
Advertisement
