Advertisement
Assembly to Helmet
1.Remove Shroud from packaging;
note Shroud is turned inside-out to
mount to Helmet.
4. Pull Shroud top fabric up over the
front TurnClip and tuck it in under
and/or close to the FCC bottom
edge all around FCC.
7. Pull Shroud over and down
the back of the Helmet.
Disassembly
Reverse Asssembly steps to remove Shroud from Helmet.
WARNING
Dispose of contaminated Shrouds according to institutional protocol for contaminated waist.
Bio-Medical Devices Intl
Page 2 01023577 Rev B
2. Grasp top of DLC Cuff and pull
gently away from Lens so that
Cuff and Flappers are away
from Lens.
5. Snap one side of DLC onto one
side FFC Attachment Post; then
snap other side.
8. Use Pull Tap to position Shroud Rear Snap
over FCC Rear Snap; snap and secure.
17171 Daimler Street
2260-05 DLC Shroud
3. Turn FCC front TurnClip horizontal and
attach Shroud front Mounting Hole
over TurnClip. Turn TurnClip vertically to
secure the attachment.
6. Hold helmet securely, grasp Shroud's
9. Snap and secure left Rear Side Snaps
Irvine, C A 92614
800-443-3842
Instruction For Use
rear Pull Tab and pull shroud up and
over helmet.
between Shroud and FCC. Then
repeat on right Rear Side Snaps.
www .maxair-systems.com
Advertisement
