Electronic Oven Controls; Display; Start; Cancel Or Off/Cancel - Whirlpool 9762354A Use And Care Manual

Style 1 - Electronic Oven Controls (on some models)
F H
G
A. Display
B. Timer
C. Clock
D. Auto clean
E. Oven light pad
(on some models)
F. Sequence programming
(on some models)
G. Oven settings
Style2 - Electronic Oven Controls (on some models)
A
I H
K J
A. Oven display
B. Clock
C. Timer/cancel
D. Start/enter (control lock)
E. Auto clean
F. Off/cancel
When power is first supplied to the appliance, "PF" or a flashing
time will appear on the display. Press CANCEL or OFF/CANCEL
to clear "PF" or flashing time from the display.
If "PF" or flashing time appears, a power failure has occurred.
Press CANCEL or OFF/CANCEL and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
8

ELECTRONIC OVEN CONTROLS

B
A
C
L
I J
K
H. Warming drawer
(on some models)
I. Temperature
J. Timed cooking
(on some models)
K. Hour/minute
(on some models)
L. Start/control lock
M. Cancel
B C D E
G
G. Temperature/time
H. Cook time
I. Start time
J. Custom broil
K. Bake

Display

D E
The START or START/ENTER pad begins any oven function. If not
pressed within 5 seconds after pressing a function pad, the
"START?" indicator light will flash as a reminder. On some
models, "START?" will appear on the display.
If not pressed within 5 minutes after pressing a function pad, the
oven display will return to the time of day mode and the
programmed function will be canceled.
M
The CANCEL or OFF/CANCEL pad stops any function except the
Clock, Timer and Control Lock.
On some models, this is a 12-hour clock that shows a.m. and
p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Depending on your model, press the HR or MIN or TEMP/
F
TIME "up" or "down" arrow pads to set the time of day,
including a.m. or p.m.
3. Press CLOCK or START.
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated (long tone)
Function has been entered
Reminder, repeating each minute after the end-of-cycle tones
Three tones
Invalid pad press
Four tones
End of cycle
Reminder Tones: Reminder tones may be turned off. On some
models, press and hold STOP TIME for 5 seconds. "rEP OFF" or
"off" will appear in the display. Repeat to turn reminder tones
back on, and "rEP on" or "on" will appear in the display.
All Tones: All of the above tones are preset on. All except the
end-of-cycle tones can be turned off.

Start

Cancel or Off/Cancel

Clock

Tones