Alert Tones - Basher NITRO CIRCUS Instruction Manual

2.9. The "timing" item is usable for sensorless brushless motors. There are many
Timing:
differences among structures and parameters of different brushless motors, so a fixed timing ESC is
difficult to compatible with all brushless motors. It is necessary to make the timing value
programmable. Please select the most suitable timing value according to the motor you are just
using. Generally, higher timing value brings out higher power output, but the whole efficiency of the
system will be slightly lower down.
2.10.
Over-Heat Protection:
temperature of the ESC is higher than a factory-preset value for 5 seconds. When the protection
happens, the Green LED will flash as "☆-, ☆-, ☆-".
2.11. You can use this item to change the rotation direction. Face to the motor shaft
Motor Rotation:
(That means the rear cover of the motor is far from your face), and move the throttle stick to the top
point of the forward zone. If this item is set to "CCW", the shaft runs counter-clockwise; If this item is
set to "CW", the shaft runs clockwise.
2.12. We strongly suggest setting the "Lipo Cells" item manually. Because the normal
Lipo Cells:
voltage of each Lipo cell varies from 2.6V to 4.2V, it is quite difficult to calculate the cells number of a
discharged Lipo battery pack. If it is calculated incorrectly, the Low Voltage Cutoff Protection
function may work abnormally, so the option "Auto Calculate" is only available for 2s, 4s and 6s Lipo.
If the voltage of the battery pack is lower than 8.8V, it is judged as a 2s Lipo; If the voltage is
between 8.8V to 17.6V, it is judged as a 4s Lipo; If the voltage is higher than 17.6V, it is judged as a
6S Lipo. So in order to make the Low Voltage Cutoff Protection function always works correctly,
please set the "Lipo Cells" item manually.
3. Program Methods
A) Program the ESC with LED program card (Optional equipment )
Please refer to the user manual of LED program card.
B) Program the ESC with the SET button on the ESC
Please refer to the instructions on page 12.
4. Reset All Items To Default Values
At any time when the throttle is located in neutral zone (except in the throttle calibration process or
ESC program mode), hold the "SET" key for over 3 seconds, the red LED and green LED will flash
at the same time , which means each programmable item has be reset to its default value.

【ALERT TONES】

1. Input voltage abnormal alert tone: The ESC begins to check the input voltage when power on, if
the voltage is out of the normal range, such an alert tone will be heard: "beep-beep-, beep-beep-,
beep-beep-" (There is 1 second interval between every group of "beep-beep-" tone).
2. Throttle signal abnormal alert tone: When the ESC can't detect the normal throttle signal, such
an alert tone will be heard: "beep-, beep-, beep-" (There is 2 seconds interval between every "beep-"
tone).
If the function is activated, the output power will be cut-off when the
10