Redlion DA 4G LTE CAT4 Installation Manual

DA 4G LTE CAT4 Sled
Installation Guide
z High-Speed 4G LTE CAT4 cellular communication
z Dual-SIM card slots for carrier fail-over
z Industrial rated for harsh environments
z Wide operating temperature range
z Built-in GPS for asset monitoring
z Simplified deployment architecture
z Field installable

PACKAGE CHECKLIST

This product package should contain the items listed below. If
any items are missing or damaged, contact Red Lion immediately.
- DA 4G LTE CAT4 Sled
- Installation Guide

SAFETY SUMMARY

All safety related regulations, local codes as well as instructions
that appear in this document or on equipment must be observed
to ensure personal safety and to prevent damage to either the
device or equipment connected to it.
Do not use these products to replace proper safety interlocking.
No software-based device (or any other solid-state device) should
ever be designed to be responsible for the maintenance of
personnel safety or consequential equipment not equipped with
safeguards. Red Lion disclaims any responsibility for damages,
either direct or consequential, that result from the use of this
equipment in a manner not consistent with these specifications.
CAUTION: Risk of Danger
Read complete instructions prior to installation and
operation of the unit.
ATTENTION : Risque de danger
Lire les instructions complètes avant l'installation et
l'utilisation de l'appareil.

SPECIFICATIONS

1. POWER REQUIREMENTS: Power is supplied by the DA host
controller.
Max Power: 3 W
2. CELLULAR FREQUENCY SPECIFICATIONS:
TECHNOLOGY BANDS
North American Models (VZ/AM)
2, 4, 5,
LTE
12, 16
HSPA+ (fallback) 2, 5 B2 (1900), B5 (850) Diversity Supported
ANTENNA
FREQUENCIES
CONFIGURATION *
B2 (1900), B4
(AWS 1700), B5
MIMO Required
(850), B12/B13
(700)
For use with DA50 and DA70 series covered in DEMKO 20 ATEX
2268X and IECEx UL 20.0007X certificates
TECHNOLOGY BANDS
Rest of the World (EU)
1, 3, 7,
LTE
8, 20
HSPA+ (fallback) 2, 5
GSM/GPRS/
3, 8
EDGE (fallback)
* GPS antenna MUST be an active antenna.
4. INTERFACES:
Cellular: Two SMA Connectors
GPS: One SMA Connector
5. GPS:
GNSS Supported: GPS L1, GLONASS L1, Galileo E1 and
BeiDouB1
High RF Sensitivity plus jamming detection
6. WIRELESS/CARRIER COMPLIANCE
PTCRB
FCC/IC
AT&T LTE with fallback to HSPA+
Generic LTE with fallback to HSPA+
Verizon LTE
7. ENVIRONMENTAL CONDITIONS:
Operating Temperature Range: -40 to 75 °C
Storage Temperature Range: -40 to 80 °C
Vibration to IEC 60068-2-6: Operational 5-500 Hz, 2 g
Shock to IEC 60068-2-27: Operational 15 g
Operating and Storage Humidity: 0 to 95% max. RH non-
condensing
Altitude: Up to 2000 meters
8. CERTIFICATIONS AND COMPLIANCES:
Refer to the controller manual for agency certifications.
CE Approved
EN 61326-1 Immunity to Industrial Locations
Emission CISPR 11 Class A
IEC/EN 61010-1
RoHS Compliant
9. ANTENNA CONNECTOR:
One front panel SMA-A main antenna connection
One front panel SMA-A GPS antenna connection
One front panel SMA-A Diversity antenna connection.
1
DA_4GLTE_Cat4 - D
Drawing No. LP1107
Revised 07/2020
ANTENNA
FREQUENCIES
CONFIGURATION *
B2 (2100), B3
(1800), B7 (2600), MIMO Required
B8 (900), B20 (800)
B2 (1900), B5 (900) Diversity Supported
B3 (1800), B8 (900) Diversity Supported