TECHWOOD TRO-1051 Instruction Manual page 9

Attaching flat beater, whisk or dough hook
The device in open position:
1. To use the mixing hook, place the splashguard on the attachment as shown in
the image and mount it on the spindle.
2. For the other 2 accessories, simply mount them on the axle (under the arm of
the device).
3. Press the lock button and lower the beater head until it locks into the closed
position.
4. Turn the attachment to snap it onto the spindle.
5. Press the attachment upward against the swivel arm and turn it counter
clockwise (To the left) at the same time, until the attachment snaps into place.
NOTES: The accessory must not be loose and it must not be possible to remove
it.
The kneading hook is used for heavy dough, minced meat or other
kneading work.
The flat beater is used to mix lighter types of pasta.
Whisk is used to whip cream, egg whites, etc.
Removing flat beater, whisk or dough hook
1. Make sure the power cord is unplugged and the shift selector is set to '0'.
2. Press the unlock button, lift the arm until the top of the unit is in the open
position.
3. Push the attachment upwards and turn clockwise (to the right) until the
attachment is released from the shaft.
4. Remove attachment from attachment shaft.
To turn the mixer on
Check that the speed selector is in position '0'.
1. Plug the unit into a wall outlet.
2. Turn the selector dial to the desired speed.
3. Once the speed is set, the mixer starts working.
Note: It is recommended to always start at the lowest speed, then increase the
speed as you go.
Place the lid on the bowl to prevent splashing.
9