Table of Contents
Advertisement
3. Remove the terminated contact by pulling the terminated wire straight from the hand tool.
TERMINAL HOLDER ADJUSTMENT(S):
TERMINAL HOLDER ALIGNMENT(S): The terminal holder assembly is designed to locate a loose-piece Dubox
terminal within the tooling to obtain a satisfactory termination form. When the terminal holder is fully closed, a magnet
stops against a setscrew to position the terminal over the anvils and obtain the optimal crimp form. Slight adjustment of
th
1/16
of a turn either clockwise or counter-clockwise to the installed setscrew with a 1.5mm Allen wrench will alter the
configuration of both the front and rear bellmouths.
NOTE: Terminate a sample and review before making additional adjustment(s).
ROUTINE MAINTENANCE
1. Use of a small brush and vacuum are the preferred methods to keep the hand tool clean of debris and
should be performed each shift, or sooner if necessary.
2. Lightly lubricate the top tooling and handle assemblies on a monthly schedule with light weight oil.
SERVICE
For service or technical help please call the FCI USA, Inc. service line at 1-800-843-6911.
PARTS REPLACEMENT
For spare part orders please call your FCI USA LLC distributor. Additionally, call1-800-222-2194 and ask for
CUSTOMER SERVICE. Please have part number(s) ready for the customer service person.
FCI USA, Inc.
Issued: Date (12/20/2012)
Manual P/N 10123594-9090
Page 9 of 9
Revision 3
TM
Advertisement
Table of Contents
