Advertisement
ATTENTION!! WHEN YOU SEE A
THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!!
Level set up area is required for use of the X-Stand treestand winch. Choosing the correct location to use the X-Stand treestand
winch is essential for safely hoisting your ladder stand. You must be aware of general treestand safety rules while using this
product. Refer to your treestands warnings and set up instructions that came with your treestand.
Begin by choosing a level area, roughly 3 to 4 feet from the tree base, as a site to insert the ground swivel pegs into the ground.
Position the lowest ladder section of your treestand on the ground where the ground spikes will be inserted. Use the two ladder
feet or vertical bars as a guide to evenly space the ground spikes, making sure the peg ends will easily fit the ladder width. This
location is where the bottom portion of the ladder will be set and will dictate the degree of angle of the ladder and platform of
your stand.
Unlevel ground at the treestand base can result in the treestand not lifting
straight while being hoisted into position with the X-Stand winch. The
treestand can fall causing structural damage to the treestand or cause
injury to anyone in the area during set up. Not heeding this warning could
result in serious injury or death.
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
BE SURE TO HEED THE MESSAGE!
Advertisement
