Advertisement
ATTENTION!! WHEN YOU SEE A
THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!!
Figure 1
Swaged end adapter
Square tube adapter
Figure 2
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
BE SURE TO HEED THE MESSAGE!
STEP 1: Getting ready to use your X-Stand winch: First thing
to do is determine the type of tubing used on the ladderstand
you will be erecting. Some X-Stand models have standard
square hollow tubing and some use oval tubing with swaged
ends. Each type will require the proper adapter pegs to be
installed on the swivel bases (Fig 1).
Next, position your fully assembled ladderstand near the tree
with the ladder laying flat on the ground. With the top seat and
platform part of your ladderstand positioned farthest from
the tree base, the treestand feet or lowest point on the ladder
should be approximately three to four feet from the tree base
(Fig 2). Distance from the tree base will vary on different height
and size treestands.
STEP 2: Install the ground swivel pegs: Be sure the "flag
ends" of the flat plates on top of the ground swivel pegs are
pointing towards the tree (Fig 3).
Figure 3
Tree
Flag end
Flag end
Advertisement
