Advertisement
Quick Links
Ladderstand Installation Kit
Item number XASA950
Always choose a straight healthy tree for use with
the Guide Gear winch. It is very important that
the tree you choose to set you stand to is straight
and devoid of limbs, nearby brush, other trees or
obstructions that could snag or catch the stand
while being erected.
Never use the Guide Gear winch or any treestand on a
tree that is dead or shows signs of decay, dead branches
or is leaning, icy, wet or has loose bark. If any of these
conditions exist or you are in doubt as to the condition
of the tree, Do not use the tree find another safe and
suitable one! Never hunt or use a on a utility pole.
Advertisement
Related Manuals for X-Stand XASA950
Summary of Contents for X-Stand XASA950
- Page 1 Ladderstand Installation Kit Item number XASA950 Always choose a straight healthy tree for use with Never use the Guide Gear winch or any treestand on a the Guide Gear winch. It is very important that tree that is dead or shows signs of decay, dead branches the tree you choose to set you stand to is straight or is leaning, icy, wet or has loose bark.
- Page 2 BE SURE TO HEED THE MESSAGE! THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!! STEP 1: Getting ready to use your X-Stand winch: First thing Figure 1 to do is determine the type of tubing used on the ladderstand you will be erecting.
- Page 3 ATTENTION!! WHEN YOU SEE A BE SURE TO HEED THE MESSAGE! THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!! Slide the swivel pegs into or over the ladder tubing (depending Figure 4 on tubing type used on your stand) (Fig 4). Make sure the treestand ladder is square with the tree, the top Swaged end adapter seat and platform of your stand will follow this angle.
- Page 4 Figure 7 X-Stand winch on the side of the tree facing the treestand. Place the X-stand winch on the ground at the base of the tree with the crank handle toward the left (Fig 7). Insert the loose end of the supplied ratchet strap through the rectangular holes located on the side of the winch bracket.
- Page 5 THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!! STEP 4: With the help of two additional adults it is now time to begin to lift your stand up using the X-Stand winch. Start by making sure the winch switch is engaged. Begin turning the crank lever slowly. Remember to watch the winch strap to be sure it doesn’t get wound up in the crank gears.
- Page 6 THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!! Level set up area is required for use of the X-Stand treestand winch. Choosing the correct location to use the X-Stand treestand winch is essential for safely hoisting your ladder stand. You must be aware of general treestand safety rules while using this product.
- Page 8 21673 Cedar Ave. South Lakeville, MN 55044 el: 540-877-2769 • fax: 952-236-6458 WWW.X-STAND.COM...