Replacing Cooktop Light; Replacing Microwave Oven Light; Troubleshooting - Whirlpool Estate TMH14XM Use & Care Manual

Estate by whirlpool microwave hood combination use & care guide
Table of Contents

Advertisement

Replacing Cooktop Light

The cooktop light is a candelabra base 30-watt bulb. See
"Assistance or Service" section to reorder.
To Replace:
1. Unplug microwave oven or disconnect power.
2. Remove the bulb cover mounting screw.
1. Mounting screw
3. Replace light. Close bulb cover. Replace mounting screw.
4. Plug in microwave oven or reconnect power.

Replacing Microwave Oven Light

The microwave oven light is a candelabra base 30-watt bulb. It
will automatically come on when the door is opened and when
the microwave oven is operating. See "Assistance or Service"
section to reorder.
To Replace:
1. Unplug microwave oven or disconnect power.
2. Remove the 2 outer vent grille mounting screws located
above the cover.
3. Tip the grille forward, then lift out to remove.
4. Lift up the bulb cover.
1
5. Replace light. Close bulb cover.
6. Reattach vent grille. Replace the mounting screws.
7. Plug in microwave oven or reconnect power.

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Nothing will operate
Has a household fuse been blown or has the circuit
breaker been tripped?
Replace the fuse or reset the circuit.
Is the appliance wired properly?
See Installation Instructions provided with your oven.
Oven will not operate
Is the door completely closed?
Firmly close door.
Is a spacer (on some models) attached to the inside of the
door?
Remove spacer, then firmly close door.
Is the electronic oven control set correctly?
See "Microwave Oven Control" section.
On some models, is the Child Lock set?
See "Child Lock" section.
Is the magnetron working properly?
Try to heat 1 cup (250 mL) of cold water for 2 minutes at
100% cooking power. If water does not heat, call for service.
See "Assistance or Service" section.
Oven makes humming noise
This is normal and occurs when the transformer for the
magnetron cycles on.
Oven door looks wavy
This is normal and will not affect performance.
1
1. Bulb cover
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents