Cleaning And Maintenance - Panasonic EP3513CU Operating Instructions Manual

Household massage lounger
Table of Contents

Advertisement

CLEANING AND MAINTENANCE

CAUTION
• Always unplug the unit before cleaning it. Never touch a power plug with wet hands.
Failure to follow these instructions may lead to electrocution or burns.
Areas Covered with Synthetic Leather
• Wipe these areas with a soft, dry cloth. (Do NOT
use cloths containing any kind of chemical, etc.)
• If the synthetic leather is particularly dirty, soak a soft
cloth in water or a 3~5% solution of mild detergent,
wring it out thoroughly and tap the surface with it.
Next, rinse the cloth in water, wring it out
thoroughly and then wipe any remaining detergent
from the surface, wipe the surfaces with a soft dry
cloth and allow them to dry naturally.
(Do NOT use a hair dryer to try to dry the surfaces
more quickly.)
• Do not allow these areas to come in contact with
plastic for extended periods of time as this may
lead to discoloration.
Moving the Unit
CAUTION
• Do not move the unit while someone is seated on it. Do not place objects on or sit, climb, or stand on
the legrest.
• When moving the unit using the wheels, remove all obstacles from around it, make sure the backrest is
in the upright position, lift it no higher than waist height (no higher than 31 in. (80 cm)) and roll it slowly.
Failure to do so may cause the unit to tip over, which may lead to damage or injury.
Lifting the Unit
• Move the chair by having one person hold onto the rubber
section on the underside of the legrest and another person
use the handle on the back of the backrest.
* Please hold the handle and legrest securely to avoid dropping
the unit as it may damage your floor.
Make sure the legrest is
retracted to the minimum length.
Hold onto the rubber section on
the underside of the legrest.
Do not hold onto the fabric.
Rubber Section
Mat
(1) Wipe the unit with a cloth that has
(2) Next wipe the unit with a cloth that
(3) Allow the unit to dry naturally.
• Please do NOT use thinners, benzine
Water
(1) Wipe the seat fabric with a cloth that
Mild Detergent
(2) Use a mild detergent and brush on
(3) Next wipe the fabric with a cloth that
(4) Allow the fabric to dry naturally.
Place the control
panel on the seat.
Handle
Place your fingers in the groove.
Pipe and Plastic Areas
been soaked in a mild detergent and
then thoroughly wrung out.
has been moistened with just water
and thoroughly wrung out.
* Make sure you thoroughly wring out
the cloth first when cleaning the
control panel.
or alcohol.
Seat Fabric
has been soaked in a mild detergent
and then thoroughly wrung out.
areas where the seat fabric has
become particularly soiled. Be careful
not to brush the fabric too much as
you may damage it.
has been moistened with just water
and thoroughly wrung out.
Using the Wheels to Move the Unit
• Move the chair by holding onto the rubber section on the
underside of the legrest and using the wheels.
(It is easier to move the unit when the massage heads are
positioned at the top of the backrest.)
* Place a mat on the floor and gently roll the unit over it to avoid
damaging the floor.
Make sure the legrest is
retracted to the minimum length.
Place the control
panel on the seat.
Roll the unit
slowly.
Mat
Wheels
Mild Detergent
Water
Water
Hold onto the rubber section
on the underside of the legrest.
Do not hold onto the fabric.
Rubber Section
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents