Connecting Your Dockcontroller Dc-200 - Motorola DOCKCONTROLLER DC-200 Quick Start Manual

CONNECTING YOUR
DOCKCONTROLLER DC-200
The DC-200 is very simple to connect. The six USB ports on the front of the unit should be used
for connecting the docks. The back two USB ports should only be used for USB configuration and
connecting an RFID reader. Also on the back is the Ethernet socket and the power socket,
as well as the function button and recessed factory reset button.
PLEASE NOTE: If you are not using a 14-Port Dock, you are restricted to connecting 4 single VB or
VT series body-worn cameras to the DockController, as it is not possible to provide sufficient power to
charge a larger number of single units.
TO SET UP YOUR DOCKCONTROLLER:
Wall mount, if required. Plug your docks into the six front-facing USB ports.
Plug a cat5e Ethernet cable into the Ethernet port on back of the device.
Plug your RFID reader, if you have one, into a into USB port on the back of the DC-200.
If configuring via USB, plug in your mass storage device next to the RFID reader.
Plug the power cable into the power socket.
Turn on power at the mains.
QUICKSTART GUIDE | DOCKCONTROLLER DC-200
Up to 4 individual VB or VT series body-worn cameras
can be connected to the ports shown.
5