Web Techniques WT-25 Owner's Manual And Manual To Operations
  1. Manuals
  2. Brands
  3. Web Techniques Manuals
  4. Industrial Equipment
  5. WT-25 Series
  6. Owner's manual and manual to operations

Web Techniques WT-25 Owner's Manual And Manual To Operations

Roll label rewind machines
Hide thumbs Also See for WT-25:
Table of Contents

Advertisement

Quick Links

Download this manual
Owner's Manual and
Guide to Operations
MODEL WT-25
ROLL LABEL
REWIND MACHINES
IMPORTANT: Read all instructions before using.
910 Bolger Court, Fenton, MO 63026 (USA) (636) 343-0806 (800) 325-9777
07-1002

Advertisement

Table of Contents
loading

Related Manuals for Web Techniques WT-25

Summary of Contents for Web Techniques WT-25

  • Page 1 Owner's Manual and Guide to Operations MODEL WT-25 ROLL LABEL REWIND MACHINES IMPORTANT: Read all instructions before using. 910 Bolger Court, Fenton, MO 63026 (USA) (636) 343-0806 (800) 325-9777 07-1002...

  • Page 2: Table Of Contents

    Table of Contents Safety Instructions ............1 Programming Deceleration and Stop Points ....4 Determining Preset B (Stop Point) ......5 Purpose (General Overview) .......... 1 Determining Preset A (Deceleration Count Setting) ... 5 Operator Controls (Web Transport System) ....1 Automatic Reset ............

  • Page 3: Safety Instructions

    at all) on vertical spindle rewind machines. Abrasive SAFETY INSTRUCTIONS materials (sandpaper rolls, etc.) will damage the ma- chine and should not be used. It is suggested that you RULES FOR SAFE OPERATION take a few minutes to become familiar with the controls 1.

  • Page 4: Stop Pushbutton

    To install a core, rotate the cam until it is flush with the body of the coreholder. Web Techniques rewind machines are available with Slide the core over the coreholder until it is resting various types of coreholders. Lift-off cam-lock core- holders are supplied as standard equipment.

  • Page 5: Air Inflatable Coreholders (Optional)

    flat on the table. Twist the core until it locks on the the rear of the main drive motor). A mating female dis- coreholder. connect is supplied as a convenience in hooking up air. The machine should be connected to an air source ca- In actual operation the cores will usually lock pable of supplying at least 50 psi.

  • Page 6: Web Path Illustration

    PROGRAMMING DECELERATION AND STOP POINTS Figure 1 Web Path for WT-25 To set the final count, press the PRE B button on the F) Press the START button. Gradually increase the counter once. In approximately two seconds the current speed setting until the web begins moving.

  • Page 7: Determining Preset B (Stop Point)

    EXAMPLE: To wind a roll of 1000 labels of 3 inch repeat The following list of settings has been pre-adjusted by length, the number 300 would be entered as the final Web Techniques, Inc. to cover most applications. If count (Preset B). these settings are not optimal for your requirements, adjustments may be made with discretion.

  • Page 8: Procedure For Re-Programming Kep Mc2A9 Counters

    6. Press ENTER. PROCEDURE FOR RE- 7. If necessary, press PRGM until “ASub b” appears. PROGRAMMING KEP MC2A9 8. Press ENTER. COUNTERS 9. If necessary, press PRGM until “Hi CPS” appears. 10. Press ENTER. UNLOCKING THE COUNTER SETTING THE RELAY OPERATION 1.

Table of Contents