Installing The Incubator - R-Biopharm Premi Test Technical Manual

6. Installing the incubator

 Place the incubator on a level surface.
 Insert the power connector of the power supply to the power input port
of the incubator. Insert the connector of the power supply itself to the
plug socket (100 - 240 V).
 The main switch is on the rear of the device. Push 'I' to switch on the
incubator, and push 'O' to switch off the incubator.
 Switch on the incubator.
 The incubator will start up in the last used program and heats up to
the last used temperature.
 During heating the 'heating' indicator flashes once per second. After
reaching the set temperature the 'heating' indicator lights constantly.
 For best results it is recommended to wait further 5 min to allow
complete temperature stabilization at the set temperature. In case of
multiple test runs during one day, leave incubator switched on and
don't put cold ampoules in the incubator during an on-going
incubation.
7. Using the incubator
7.1 Check the current program
 Press 'Prog' and '' at the same time
 The display will show either 'Program A' or 'Program b'
7.2 Choosing the incubation program
 Press and hold 'Prog' and '' at the same time for 10 s
 Press '' or '' to switch between the two programs
 Press 'Start/Stop' to select a program
2014-12-11 18 R-Biopharm AG