Advertisement
Chromoflex - Manual - English V1.07
2. Pushed twice: effect 6: Fire „Fire"
Button 3:
1. Pushed once: effect 3: „Blob"
2. Pushed twice: effect 7: Lightning „Flash"
Button 4:
1. Pushed once: effect 4: User colour change
2. Pushed twice: effect 8: „Burst"
Button 1:
1. Pushed once: effect 1 (normal colour change)
2. Pushed twice: effect 5: „LSD"
Button 2:
1. Pushed once: effect 2 (Soft colour change)
2. Pushed twice: effect 6: Fire „Fire"
Button 3:
1. Pushed once: effect 3: „Blob"
2. Pushed twice: effect 7: Lightning „Flash"
Button 4:
1. Pushed once: effect 4: User colour change
2. Pushed twice: effect 8: „Burst"
Important! Shutdown: if any button is pressed longer than about 3 seconds, all modules are switched
off; any other button will start its assigned effects.
The DIP-Switches - Default-Effects
Some settings (i.e. the default effect after reset or power on) can be preset with the internal DIP
switches. In this case the cover of the module must be opened (see attachment).
Important: Please do not touch any of the electronic components, because of the risk of damage by
electrostatic discharge. We recommend using a small non-conductive tool to change the DIP
switches.
The switches are separated in 3 groups (as imprinted):
DIP 1, 2: These two switches control hold time for effects 1 and 2 (colour changes):
DIP 1
DIP 2
Off
Off
On
Off
Off
On
On
On
DIP 3, 4, 5: These switches are for the default effect after reset or power on.
DIP 3
DIP 4
DIP 5
Off
Off
Off
On
Off
Off
Off
On
Off
On
On
Off
Off
Off
On
On
Off
On
Off
On
On
On
On
On
DIP 6, 7, 8 determine the „Group" of a module. Because the modules can be connected as a network,
it should also be possible to send commands only to a part of the network. This is what we call a
„Group". For example, if several modules are used for a pool illumination (ceiling, walls under-water)
these modules could be separated into three groups. Now it is possible to send commands i.e. only to
the modules on the ceiling. More information can be found in the following paragraph „A Pool
Scenario"..
- www.barthelme.de
Effect 1
Effect 2
5 sec.
30 sec.
10 sec.
60 sec.
30 sec.
120 sec.
90 sec.
180 sec.
Effect
Effect 1: Standard colour change, colour transition time 2.5 seconds (default)
Effect 2: Slow colour change, colour transition time 10 seconds (default)
Effect 3: Randomly faded colours „Blob"
Effect 4: User defined colour change (can by changed by PC software
Effect 5: Randomly changed colours „LSD"
Effect 6: Simulation Fire „Fire"
Effect 7: Simulation Lightning („Flash")
Effect 8: Randomly coloured flashes („Burst")
(default)
- 9 -
Rev. 19.08.2010
Advertisement
