Advertisement
Chromoflex - Manual - English V1.07
Chromoflex module with (plugged) receiver
The cables for the infrared receiver can be extended from 20 to 100 cm. Shielded cables are
recommended with lengths of more than 20 cm. The shield can be connected to the free pin of the
receiver's socket. If touching electronic parts, please observe the common known handling
instructions for electrostatic sensitive devices (ESD). Please discharge yourself.
Important: If polarity of the infrared receiver is reversed, receiver and ChromoFlex module can be
damaged!
Important: If polarity of the infrared receiver is reversed, receiver and ChromoFlex module can be
damaged!
Infrared-Remote-Control – Operating
A precondition is that an infrared receiver is connected to the ChromoFlex module.
See chapter above. The 4 large buttons on the remote control are equivalent to the
4 „standard" buttons
Upper Channel +button is button 1,
Right Volume + button is button 2,
Lower Channel button„-' is button 3,
Left Volume - button is button 4.
The crossed out earphone button is Learn-Mode.
Programme-Mode
8 pre-programmed Effects are available.
Button 1:
1. Pushed once: effect 1 (normal colour change)
2. Pushed twice: effect 5: „LSD"
Button 2:
1. Pushed once: effect 2 (Soft colour change)
2. Pushed twice: effect 6: Fire „Fire"
Button 3:
1. Pushed once: effect 3: „Blob"
2. Pushed twice: effect 7: Lightning „Flash"
Button 4:
1. Pushed once: effect 4: User colour change
2. Pushed twice: effect 8: „Burst"
- www.barthelme.de
Module with extended cable (abt. 20 cm)
- 11 -
Rev. 19.08.2010
Advertisement
