Initial Operation; Mounting Grip Rod; Mount Ejector Chute And Shift Linkage; Adjust The Ejector Chute - Grizzly ESF 2046 L Translation Of The Original Instructions For Use

GB

Initial Operation

Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Remove the transport securing
devices before you start with the
assembly.

Mounting grip rod

Mount central bar:
1. Place the central bar (7) on the
lower bar (10). If the assembly
is correct, the bore in the plastic
shroud (22) will be underneath
the pipe (see
2. Screw the central bar (7) with the
enclosed screws, butterfly nuts
and washers (12) right and left
on the lower bar (10). The but-
terfly nuts are pointing outwards.
Mount top grip bar:
3. Screw the top grip bar (1) with
the enclosed screws, butterfly
nuts and washers (6) right and
left on the central bar (7). The
butterfly nuts point inwards.
Clip in cable holder:
4. Clip the enclosed cable holder
(8) on the central bar (7) and use
it to secure the machine cable
(21).
Mount ejector chute and shift
linkage
Mount ejector chute:
1. Place the ejector chute (16) on
the machine housing (11) and
screw this with the 4 enclosed
cross-head screws (26).
48
).
Mount shift linkage
2. Push the top shift rod (5) through
the opening in the plastic shroud
(22) on the central bar (7).
3. Release the fastening screw (27)
on the lower shift rod (9).
4. Push the top (5) and bottom
(9) shift rod together and screw
them with the fastening screw
(27).
5. Push the handle of the top shift
rod (5) in both directions. The
ejector chute (
able to move freely.

Adjust the ejector chute

The following settings are possible:
- Turning the ejector chute to the right or
left through a total of 190°;
- Tilting the ejector chute up or down
through 60°;
The steeper the ejector deflector (19),
the further the snow will be thrown.
1. Bring the ejector chute (16) into
the required direction by turning
the handle (5) of the shift link-
age.
2. Release the butterfly nuts (18)
on the ejector chute and fold the
ejector deflector (19) into the re-
quired position.

Operation

Switching ON and OFF

1. Make a loop in the end of the ex-
tension cable and suspend this
in the cable strain relief (23).
2. Connect the machine to the
power supply.
16) must be