Program Play - Panasonic SC-AK200 Operating Instructions Manual

4
1
2
PROGRAM
3
4
5
7
A
B
3
5
2
1 • 7
Specified track number
Program order
Indicates program mode
Listening to compact discs

Program play

Remote control only
You can program up to 24 tracks.by remote control only
1
Press [CD :/ J] and then [L].
2
Press [PROGRAM].
3
Press [DISC].
4
(within 10 seconds or so)
Press [1] – [5] to select the disc you want.
5
Press the numeric button to select the
desired track.
6
Repeat steps 3 through 5 until you have
programmed all the tracks you want.
7
Press [CD : : : : : / J J J J J].
Play will start in the programmed sequence.
To cancel program play mode
Press [PROGRAM] in the stop mode.
Programmed contents will be saved in memory.
To clear all programmed tracks
Press [L] in the stop mode. "CLEAR" is displayed.
To select a two-digit track
Press [ 10] and then the two numbers you want within 10 seconds or
so.
For example
Track no. 20: [ 10] [2] [0]
Track no. 35: [ 10] [3] [5]
A
When "CD FULL" appears
The number of programmed tracks is limited to 24. No further
tracks can be programmed.
B
You can do the following during program mode:
•
Check program contents.
Press [g/REW/4] or [3/FF/f].
Every time you press one of the buttons, the track and program
No. are shown on the display.
•
Add to the program.
Repeat steps 3 through 5.
Memory retention
Your program is retained in memory for about 2 weeks while the
system is unplugged.
To replay your program
If you turned OFF your program with [PROGRAM], you can play it
again as explained below.
1. Press [PROGRAM].
2. Press [CD :/ J].
If you program a track not on your CDs
The track is initially programmed, but during program play, the player
will skip that track and will continue playing from the next programmed
item.
17
RQT6085