Using The Appliance - Philips 1000 Series Manual

- Always check the appliance
before you use it. Do not use
the appliance if it is damaged,
as this may cause injury.
Always replace a damaged
part with one of the original
type.
- Do not open the appliance to
replace the rechargeable
battery.
Caution
- Never immerse the appliance
in water. Do not use the
appliance in the bath or
shower.
- Never use water hotter than
60°C to rinse the appliance.
- Only use this appliance for its
intended purpose as shown
in the user manual.
- If you use the appliance to
clip the hair of more than one
child, clean the appliance
before you used it on another
child.
- Never use compressed air,
scouring pads, abrasive
cleaning agents or aggressive
liquids such as petrol or
acetone to clean the
appliance.
- Do not use the supply unit in
or near wall sockets that
contain an electric air
freshener to prevent
irreparable damage to the
supply unit.
Electromagnetic fields (EMF)
- This Philips appliance complies with all
applicable standards and regulations regarding
exposure to electromagnetic fields.
General
- This appliance can be safely cleaned under the
tap (Fig. 3).
- The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.
- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
- Maximum noise level: Lc = 75 dB(A).
Preparing for use
Charging
Charge the appliance for at least 8 hours before
you use it for the first time, after a long period of
non-use or when the motor starts to run more
slowly during hair clipping.
When the appliance is fully charged, the appliance
has a cordless operating time of up to 45 minutes.
Note: Do not leave the appliance connected to the
wall socket for more than 24 hours
1 Switch off the appliance.
2 Insert the small plug into the appliance and put
the supply unit in the wall socket (Fig. 4).
- After a few seconds, the charging indicator
lights up green continuously to indicate that the
appliance is charging (Fig. 5).
3 After charging (approx. 8 hours), remove the
supply unit from the wall socket and pull the
small plug out of the appliance.
Charge indications
Battery low
The battery status is indicated by the performance
of the appliance. When the appliance starts
working more slowly, the battery is almost empty
and needs to be charged for optimal performance.
Charging
When you charge the appliance, the charging
indicator lights up green continuously to indicate
that the appliance is charging (Fig. 5).

Using the appliance

Note: This appliance can be used without cord or
when it is connected to the wall socket (Fig. 6).
Switching the appliance on and off
- To switch on the appliance, push the on/off
slide upwards (Fig. 7).
- To switch off the appliance, push the on/off
slide downwards.
Removing or attaching combs
1 To remove the comb, push one lug backwards
off the appliance until the comb detaches from
the appliance (Fig. 8).