Advertisement
Quick Links
Mounting
The CMC-1001 mounts directly on MCP-1030/1130/
1040/1140/1160/5140/5160 series actuators.
1. At the mounting location, remove one of the
screws or bolts that holds the actuator housing
together. Do NOT remove more than one
actuator screw or bolt.
2. Slide the positioner over the mounting boss.
3. Reinstall the screw or bolt. Be careful not to
cross-thread the actuator housing.
4. Using the proper hole in the feedback arm (VTD-
1500), slide the arm over the actuator shaft. The
arm is held between the shaft and the damper
linkage.
5. Connect the 5 psi or 10 psi feedback spring
(ordered separately—see chart) to the hole at the
base of the feedback arm.
CMC-1001
Installation Guide
6. Connect the other end of the feedback spring
1
Non-Metallic Positive Positioner
to the feedback chain. There should be no slack
between the positioner and the arm.
All dimension are in inches (mm)
CMC-1001
Installation Guide
Advertisement
Related Manuals for KMC Controls CMC-1001
Summary of Contents for KMC Controls CMC-1001
- Page 1 Non-Metallic Positive Positioner CMC-1001 Installation Guide Mounting The CMC-1001 mounts directly on MCP-1030/1130/ 6. Connect the other end of the feedback spring to the feedback chain. There should be no slack 1040/1140/1160/5140/5160 series actuators. between the positioner and the arm.
- Page 2 Inc. makes no representations or warranties with respect nent is designed for dependable, long-term reliabil- to this document. In no event shall KMC Controls, Inc. ity, and performance. Careful installation will also be liable for any damages, direct or incidental, arising ensure long-term reliability and performance.
Need help?
Do you have a question about the CMC-1001 and is the answer not in the manual?
Questions and answers