Switching The Light On And Off; Removing Obstructions And Blockages; Cleaning/Maintenance; General Cleaning And Maintenance Work - Grizzly ESF 2046 L Translation Of The Original Instructions For Use

• Clear snow when it is loose, freshly
fallen, as the layer of snow can turn to
ice later, making the work more difficult.
• Do not use the machine with snow that
is very hard and frozen. The rubber
covering of the auger could be dam-
aged.
• Clear the snow in the wind direction as
far as possible.
• Switch the machine off and tilt it, if you
have to cross a gravel path or sensitive
surfaces.
• The carry handle (
machine easier to transport.
• Allow the motor to run for a short period
of time after you have completed the
work so that any moisture is removed
and no moving parts can freeze.
• Clean the machine after each use, as
described in the section "Cleaning/
Maintenance".

Switching the light on and off

The light only works while the machine is in
operation.
1. To switch on the light (4), place
the on/off switch (3) in position "I".
2. To switch off the light (4), place
the on/off switch (3) in position
"0".
Removing obstructions and
blockages
Attention! Shut off motor before
unclogging discharge chute.
Snow can block the auger or the ejector
chute.
• Remove any blockages carefully with a
piece of wood or plastic.
17) makes the
Do not use any hard or sharp objects,
as these could damage the machine.

Cleaning/Maintenance

Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Before any maintenance and
cleaning works are carried out:
Switch the machine off, disconnect
the power lead and ensure that
all movable parts have stopped
moving. There is a risk of personal
injury.
General Cleaning and Mainte-
nance Work
Do not jet water onto the appli-
ance and do not clean it under
flowing water. This would result
in the danger of an electric
shock and the trimmer could be
damaged.
• Keep the ventilation channels, motor
housing and handles of the machine
clean. Use a damp cloth or a brush to
clean them.
Do not use any cleaning agent or sol-
vent. This could damage the machine
irreparably.
• Clean the ejector chute and the auger
of any snow residues after each use.
• Prior to every use, check the appli-
ance for obvious defects such as
loose, worn or damaged parts. Check
that all nuts, bolts and screws are sit-
ting firmly.
• Check the covers and protective de-
GB
53