Advertisement

Quick Links

Installation Manual
For General Installation. Model-speci c manuals will be included with multi-zone condensers or as applicable.
Olympus Series
Single (Hyper Heat & Energy Star) & Multi-Zone Models
For more details visit www.MrCool.com

Advertisement

Table of Contents
loading

Summary of Contents for MrCool Olympus Hyper Heat Series

  • Page 1 Installation Manual For General Installation. Model-speci c manuals will be included with multi-zone condensers or as applicable. Olympus Series Single (Hyper Heat & Energy Star) & Multi-Zone Models For more details visit www.MrCool.com...
  • Page 2 CONTENTS PRECAUTIONS 9K & 12K INSTALLATION 18K & 24K INSTALLATION For more details visit www.MrCool.com...
  • Page 3 PRECAUTIONS Installation Precautions Safety Precautions WARNING CAUTION WARNING CAUTION For more details visit www.MrCool.com...
  • Page 4 9K & 12K Installation - INSTALLATION LOCATION Indoor Unit Outdoor Unit Required Greater For Ceilings Than Foot Suggested Floor Clearance is 230cm(90.55in) Suggested Less For Ceilings Than Foot Suggested Floor Clearance is 200cm(78.55in) For more details visit www.MrCool.com...
  • Page 5 9K & 12K Installation - ACCESSORIES Smart Controller Kit Neoprene (1) (1) (w/ Manual) (Sealant for Wall Sleeve) 9K & 12K Installation - OUTDOOR MOUNTING DIMENSIONS NOTE: Outdoor unit dimension Mounting dimensions in/mm (WxHxD) A(in/mm) B(in/mm) For more details visit www.MrCool.com...
  • Page 6 Right rear side Left rear side refrigerant refrigerant 1.8in/45mm pipe hole pipe hole 2.6in/65mm 2.6in/65mm Series 18K Models Right rear side Left rear side refrigerant refrigerant pipe hole pipe hole 2.6in/65mm 2.6in/65mm Series 24K Models For more details visit www.MrCool.com...
  • Page 7 • Outdoor power cable is not provided Appliance Amps AWG Wire Size • Indoor power / signal cable from outdoor unit is provided • See table below for gauge requirements Appliance Model Series Amps (A) 9K & 12K For more details visit www.MrCool.com...
  • Page 8: Power Supply

    9K & 12K Installation - WIRING Indoor Wire Connection Outdoor Wire Connection Connection Diagrams 115V~ models 1(L ) 2(N ) S Power supply 208-230V~ models Power supply For more details visit www.MrCool.com...
  • Page 9 9K & 12K Installation - INSTALLATION PROCESS NOTE: NOTE: Using manual operation For more details visit www.MrCool.com...
  • Page 10 18K & 24K Installation - INSTALLATION LOCATION 9K & 12K Installation - INSTALLATION LOCATION Indoor Unit Outdoor Unit Required Greater For Ceilings Than Foot Suggested Floor Clearance is 230cm(90.55in) Suggested Less For Ceilings Than Foot Suggested Floor Clearance is 200cm(78.55in) For more details visit www.MrCool.com...
  • Page 11: Air Inlet

    3. Clean concrete dust away from holes. WHEN DRILLING INTO CONCRETE, EYE 4. Place a nut on the end of each expansion bolt. PROTECTION IS RECOMMENDED AT ALL TIMES. 5. Hammer expansion bolts into the pre-drilled holes. For more details visit www.MrCool.com...
  • Page 12: Mounting Indoor Unit

    Mount the Installation Plate and drill holes in the wall according to the wall structure 39in Series 18K Models unless otherwise stated.) Correct orientation of Installation Plate 46.7in Series 24K Models Dill a Hole in the Wall For more details visit www.MrCool.com...
  • Page 13 • Indoor power / signal cable from outdoor unit is provided • See table below for gauge requirements Appliance Model Series Amps (A) 9K & 12K Indoor Wire Connection Outdoor Wire Connection 208-230V~ models Power supply For more details visit www.MrCool.com...
  • Page 14 Refer to Fig. 3.4 for details. Knock-out Panel Fig. 3.3 Fig. 3.4 CAUTION Be extremely careful not to dent or damage the piping while bending them away from the unit. Any dents in the piping will affect the unit’s performance. For more details visit www.MrCool.com...
  • Page 15: Indoor Unit Installation

    PLUG THE UNUSED DRAIN HOLE water or in containers To prevent unwanted leaks you must plug that collect water. This the unused drain hole with the rubber plug will prevent proper provided. drainage. Fig. 3.8 For more details visit www.MrCool.com...
  • Page 16: Drain Joint Installation

    18K & 24K Installation - INDOOR INSTALLATION Indoor Unit Installation 18K & 24K Installation - OUTDOOR INSTALLATION Incorrect Correct Barrier Strong Strong wind wind Drain Joint Installation NOTE: Base pan hole Drain joint Seal of outdoor unit For more details visit www.MrCool.com...
  • Page 17 9.52mm (255kgf.cm) (265kgf.cm) 3500 3600 12.7mm (357kgf.cm) (367kgf.cm) 4700 4500 16mm (459kgf.cm) (479kgf.cm) Outdoor Electrical Connections Cover Screw Outdoor Unit Wiring Diagram is located on the inside of the wire cover on the outdoor unit. For more details visit www.MrCool.com...
  • Page 18: Air Purging

    Liquid side a spanner wrench. Valve body Packed valve Flare nut Valve stem Using the Vacuum Pump Manifold valve Compound meter Pressure gauge -76cmHg Handle Hi Handle Lo Charge hose Charge hose Vacuum pump Packed valve For more details visit www.MrCool.com...
  • Page 19: Leak Check

    C over Outdoor unit chec k point CAUTION A: Lo packed valve B: Hi packed valve C and D are ends of indoor unit connection. Test Run AUTO/COOL Manual control button Manual control button For more details visit www.MrCool.com...
  • Page 20 Olympus Series Single (Hyper Heat & Energy Star) & Multi-Zone Models For more details visit www.MrCool.com...

Table of Contents