Champion Classic Series Operating Instructions And Service Manual page 38

APPENDIX B (continued) – Heated and Heat/Massage Recliners
Please reference previous operation instruction information for all operating instructions for
positioning of the chair. This includes the use of the Trendelenburg option if your chair is so
equipped.
Uncoil the power cord on the back of the chair and plug it into any properly grounded standard
wall outlet. You will find the heater power button on the table of the chair. This will typically be
the right table (while seated in the chair) unless other options require it to be on the left side.
Pressing the button the first time will start the heater at low power and all one light will
come on. At this setting it will take approximately 16.5 minutes to come to full heat with an
occupant in the chair. Pressing the button a second time will take the heater to medium power
(two lights on) and a third will take it to high (three lights on). To turn the heater off, press the
button a fourth time and all of the lights will be out.
NOTE: The heat system is set to turn off 30 minutes after the last button press. Repeat
the above process to continue use of the heat feature.
NOTE: If the lights on the switch are flashing, FIRST unplug the chair from the outlet and
check all of the connectors of the heat system. If a connector is unhooked reconnect it,
plug in the power cord, and check the switch again. If all connections appear ok and the lights
still flash, unplug your chair and contact Champion's customer service. This does not affect the
basic functions of the chair.
POSITIONING THE CHAIR
OPERATING THE HEATER
LIGHTS
SWITCH DETAIL
(37)
BUTTON
OM00REC Recliner Manual REV 8 080119