Table of Contents
Advertisement
APPENDIX B (continued) – Heated and Heat/Massage Recliners
Please reference previous chair specification pages for all load and dimensional specifications of
your heated chair. All chairs with heat are built to properly handle the specified load for that
model chair. The heater option does not change the size or load capability of that model.
Power Requirements
Input: 100-240 VAC, 1.0 A max, 50-60 Hz
Output: 12 VDC, 3.5 A, 42 W
Average Measured Maximum Temperatures
WARNING: No items should be placed behind the occupant's back or beneath
them. Placing items (pillow, blanket, etc.) in the chair will expose the item to the heat
generated by the system. Unlike the occupant's body, certain items may not absorb
and dissipate the generated heat; this may expose the item to temperatures that are
higher than noted here through trapped heat.
the item, and risk of contact with higher temperatures. Damage to the item or your
chair is not covered by your warranty.
NEW HEAT AND HEAT/MASSAGE CHAIR INSPECTION:
Reference earlier section on receiving new chairs, along with the following operational procedures.
WARNING: The heat or heat/massage chair must be plugged into a properly
grounded outlet and must not be modified in any way. If the three (3) blade plug does
not fit your outlet, have one installed that meets your local codes by an electrician.
Consult an electrician if you are unsure that the outlets are properly grounded. Do not
use a three (3) blade plug to a two (2) blade adapter.
CAUTION: Before plugging chair into wall outlet, it should be checked for
condensation on the electrical components and dried if necessary. The chair should
reach room temperature prior to plugging it in.
CHAIR SPECIFICATIONS
LOW
MEDIUM
HIGH
RECEIVING NEW CHAIRS
(34)
98
O
F
102
F
O
105
O
F
This may cause damage to the chair,
OM00REC Recliner Manual REV 8 080119
Advertisement
Table of Contents
