Table of Contents
Advertisement
Available languages
Available languages
2. Remove the water inlet hose.
3. Remove the drain hose from the rear support
and unhook it from sink or spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the hoses.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
INTRODUCTION
The appliance does not start or it stops during
operation.
First try to find a solution to the problem (refer to
the table). If the problem persists, contact the
Authorised Service Centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
POSSIBLE FAILURES
Problem
The programme does not
start.
The appliance does not fill
with water properly.
16
5. When no more water flows, install the inlet
•
•
•
•
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that the appliance door is closed.
•
Make sure that there is not a damaged fuse in the fuse box.
•
Make sure that the Start/Pause has been pressed.
•
If the delay start is set, cancel the setting or wait for the end of
countdown.
•
Deactivate the Child Lock function if it is on (if available).
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter of the inlet hose and the filter of the valve
are not clogged. Refer to "Care and cleaning".
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the connection of the water inlet hose is correct.
•
Make sure that the drain hose is in the correct position. The hose
may be too low.
hose and the drain hose again.
WARNING! Make sure that the
temperature is more than 0 °C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
- The appliance does not fill with water
properly.
- The appliance does not drain the water.
- The appliance door is open or not
closed correctly. Please check the door!
- The mains supply is unstable. Wait until
the mains supply is stable.
WARNING! Deactivate the appliance
before you do the checks.
Possible solution
Advertisement
Table of Contents
