Condition Monitoring Functions; Communication Functions - ABB REF 54 Series Technical Reference Manual, General

1MRS750527-MUM
Table 5.1.1.4-1 Control functions available for REF 54_ (Continued)
Function ANSI device no. IEC symbol
MMIDATA1 MMIDATA1
MMIDATA2 MMIDATA2
MMIDATA3 MMIDATA3
MMIDATA4 MMIDATA4
MMIDATA5 MMIDATA5
5.1.1.5.
Table 5.1.1.5-1 Condition monitoring functions available for REF 54_
Function ANSI device no. IEC symbol
CMBWEAR1 CB wear1
CMBWEAR2 CB wear2
CMCU3 MCS 3I
CMGAS1 CMGAS1
1) CMGAS3
CMGAS3
CMSCHED CMSCHED
CMSPRC1 CMSPRC1
CMTCS1 TCS1
CMTCS2 TCS2
CMTIME1 TIME1
CMTIME2 TIME2
CMTRAV1 CMTRAV1
CMVO3 MCS 3U
5.1.1.6.
Feeder Terminal
Technical Reference Manual, General
Description
MMIDATA1 MIMIC data monitoring point 1
MMIDATA2 MIMIC data monitoring point 2
MMIDATA3 MIMIC data monitoring point 3
MMIDATA4 MIMIC data monitoring point 4
MMIDATA5 MIMIC data monitoring point 5
1) This function is only supported in the feeder terminal revisions of Release 2.0 or later, refer to Section
"Revision identification" on page 105.

Condition monitoring functions

Description
CB wear1 Circuit-breaker electric wear 1
CB wear2 Circuit-breaker electric wear 2
MCS 3I Supervision function of the energizing current input circuit
GAS1 Gas pressure monitoring
GAS3 Three-pole gas pressure monitoring
SCHED Scheduled maintenance
SPRC1 Spring charging control 1
TCS1 Trip circuit supervision 1
TCS2 Trip circuit supervision 2
TIME1 Operate time counter 1 for the operate time used (e.g. motors)
TIME2 Operate time counter 2 for the operate time used (e.g. motors)
TRAV1 Breaker travel time 1
MCS 3U Supervision function of the energizing voltage input circuit
1) This function is only supported in the feeder terminal revisions of Release 2.0 or later, refer to Section
"Revision identification" on page 105.

Communication functions

The REF 54_ feeder terminal provides the IEC_103, Modbus, DNP 3.0, SPA and
LON serial communication protocols.
In a customer-specific feeder terminal configuration, special events can be generated
via an EVENT230 event function.
For more information about communication in the REF 54_ feeder terminal, refer to
Section "Serial communication" on page 67.
REF 54_
25