Specifications And Information - Panasonic ShowStopper PV-HS2000 Operating Instructions Manual

Specifications & Information
Specifications
General
Operating voltage
Power Consumption
Tuner
MTS
Input Connectors
Tuner
Composite
Audio
S-Video
Output Connectors
Composite
Audio
S-Video
Telephone
Serial Control
IR Blaster
Dimensions/Weight
Height
Width
Depth
Weight (net)
Audio/Video Signals
Audio output level
Video output level
Video output impedance
Operating/Storage Conditions
Operating temp. range
Storage temp. range
Record
HDD Capacity
Video compression format MPEG2
Audio compression format MPEG1 layer2
Recording level
Recording time
MODEM
Speed
* Actual available recording time is not maximum because the
"Welcome Video" is already recorded in the Replay Guide.
To make the most of the available recording time, delete the
welcome video from the Replay Guide or save it to a
videotape.
120VAC 60Hz
28W (Power On)
19W (Power Off)
Type F
Phono x 2
Phono (L+R) x 2
4-pin miniature DIN
Phono x 2
Phono (L+R) x 2
4-pin miniature DIN
RJ-11, 2wire
DB-9
76mm
430mm
290mm
5.9kg
2.0Vp-p
1.0Vp-p
75 ohm
+5 °C to +40 °C
-20 °C to +55 °C for 100 hours
20.4GB
Extended/Medium/High
30H/15H/10H*
56kbps
Resetting Hard Disk Recorder
If the Hard Disk Recorder does not respond
when you press buttons on the remote, press
and hold the POWER button on the front of
the unit for 10 seconds. The Hard Disk
Recorder will start up in a few moments.
The Hard Disk Recorder's green power LED
does not need to be lighted to record shows.
If you have a cable box or a satellite receiver,
however, these device must remain on for the
Hard Disk Recorder to record from them.
Screen Burn In
When any image is displayed on a television
screen for an extended period of time, a
permanent mark can remain even after the
image is changed. This is called "screen burn
in." Projection TVs are the most susceptible to
screen burn in. To prevent this, don't leave the
Channel Guide, or any other screen displayed
when you don't need to use them. You can
also adjust the brightness of the Hard Disk
Recorder screens to help prevent this. See
"Change Display Brightness" on page 7.
NOTE
•
To dismiss the Pause on-screen image from your TV
screen and keep a show paused, press the EXIT
button on the remote control.
53