Putting On The Freewheel Body And The End Caps; Checking The Function - DT SWISS RATCHET EXP Technical Manual

2.15 PUTTING ON THE FREEWHEEL BODY AND THE END CAPS

1. Put the freewheel body onto the hub.
2. Check if the freewheel body can be turned
and if the ratchets are engaging.
3. Grease both bearings and the inner side of
both end caps.
4. Put on the left and the right end cap.
→ The shorter adapter must be placed on
the drive side.

2.16 CHECKING THE FUNCTION

1. Turn the freewheel body in both directions.
→ The freewheel body can be turned
counterclockwise smoothly.
The ratchets engage audibly and
perceptibly.
→ The freewheel body cannot be turned
clockwise.
2. Check the end caps for tight fit.
→ The end caps are firmly seated on the
axle and are completely pushed on.
Ratchet EXP - Technical Manual 19