GE TFK Series Technician Manual page 24

1997 REFRIGERATORS GLOBAL NEW GENERATION
SxS
channels with a soft rubber mallet.
Recess Assembly
To dismount the recess assembly --
first, remove the recess trim. Then,
remove the screws at the perimeter of
the recess housing. Gently pull the
recess assembly at the left side
until it is out of the opening in the
freezer door. (The wiring harness,
extending above the recess, and the
water tubing, extending below the
recess, will prevent complete removal
of the recess assembly.)
To remount the recess assembly --
position it into the opening in the
freezer door, beginning at the top
and right side. Position the water
tubing behind the recess housing and
into the groove in the foam
insulation. Caution: unless the
tubing is in the groove, it may
become pinched and interfere with the
installation of the recess assembly.
Dress the wiring harness at the upper
left side to prevent pinching of
wires. Engage the ice chute into the
duct opening at the top of the recess
housing. Then, push the recess
assembly to firmly seat it in the
opening in the freezer door.
Reinstall the screws at the perimeter
of the recess housing. Reinstall the
recess trim.
Water Tubing
To remove the water tubing -- first,
dismount the freezer door from the
cabinet and place it on a protected
surface so that the outer door is facing
upward. Then, dismount the recess
assembly. Remove the screws and retainer
23
© General Electric Company 1997