Pins - Urban Air Pro Zone Operation & Maintenance Manual

• Inspect this equipment before each day of operation to determine that no part of this equipment is
damaged, missing, or worn in such a manner that unsafe conditions can develop.
• Perform our recommended maintenance procedures at the intervals specified and in the manner
described in this manual.
• Study each job carefully to determine all hazards so that necessary safeguards can be taken.
• Examine safety devices (tools, ladders, etc.) before they are used to make sure they are in good
condition. Use only OSHA approved safety items. Ladders must be clean and unpainted.
• Use the proper tool or equipment for each job. Ground all hand electric power tools before use.
• Wear close-fitting, comfortable clothing when working on or close to moving parts or live electrical
circuits. Avoid finger rings, jewelry, or other articles which can be caught in moving parts or come in
contact with electrical circuits.
• Protect your eyes by wearing approved safety glasses or goggles.
• Wear a hard hat at all times. When working in elevated area, use a safety belt.
• When work to be performed is hazardous, at least two persons shall work together.
• If guards must be removed from equipment, make sure they are replaced before leaving the job.
Check that all safety decals, signs, and placards are properly installed and legible.
• Clean up after each job, and properly dispose of surplus materials.
• Keep a record of parts replaced and the date of replacement. Inform the manufacturer of any
replacement requirements that are frequent or cause unsafe conditions.

7.1 Pins