Parts; Selection Of The Temperature; Instrucrions For Use; Selection Of The Running Time - Johnson Relax Model Double Instructions For Use Manual

PARTS

A. Heating element body area
B. Heating element feet area
C. Microcomputer removable
with general On-Off button, timer push-
button,
thermostat button body area and ther-
mostat button feet area.
D. Main switch On-Off
E. Thermostat button body area
F. Thermostat button feet area
G. Timer button
H. Numerical indicator body thermostat
L. Numerical indicator feet thermostat
M. Warning light of the timer
N. Plug for connection to electricity net-
work
P. Microcomputer connector
Q. Socket of the heating elemets

INSTRUCRIONS FOR USE

Posizioning the electric under-blanket.
- The electric underblanket should be
placed on a fixed mattress and resistant
- Placed the resistors and connector side
(L) in contact with the mattress and the
side with synthetic wool turned upward.
Take care that the blanket is fully exten-
ded above the mattress in the area wi-
thout the pillows. Unwind completely
the connector cable and the power cord.
- The socket of the heating element (Q)
must be close the shoulders for ease of
use, and to properly use the heating fun-
ction in 2 areas.
- Attach the blanket to the mattress
using the tapes and the eyelet located
on the edge. (The folded parts can cause
high temperature so can be dangerous).
- To keep the electric underblanket spre-
ad, clean and without folds, place always
also the sheet. (Do not interpose blan-
kets or other cloths, as this will difficult
the heat diffusion).
- The microcomputer (C) must be left out-
side not under the pillow, or anything to
not apply pressure on it.
The electric blanket must be preheated
from 30 minutes to 1 hour before use.
Make sure che connector of the micro-
computer (P) is plugged correctly into
the socket of the heating element (Q).
Make sure the general key (D) is on Off.
Insert the connection plug (N) into a sui-
table mains supply socket.
Turn on the appliance placing the switch
(D) on On.
The appliance in set to work one hour at
full power in both areas, body and feet.
With the switches you can change the
settings as desired.

SELECTION OF THE TEMPERATURE

Pressing the buttons feet (F) and body
(E) areas thermostat is set separately the
power with values from 0 (off) to 9 (ma-
ximum power).
Important: The time required for heating
the electric blanket may vary depending
on the ambient temperature conditions.
The temperature level of the electric
blanket must be judged by lying in bed.
Do not judge the temperature of the
electric blanket by simply resting your
hand, because the hand is not sensitive
enough to heat and does not allow to
judge the need of the body at best.

SELECTION OF THE RUNNING TIME

Pressing timer (G) button is set the ope-
ra- ting time after which the blanket au-
tomatically will turn off .
The set option (1h , 5h, 8h, 12h) is di-
splayed by the indicator light (M)
- Set the desired temperature for the
night. We suggest an average tempera-
ture to keep heat.
If you do not desire heat for all night,
choose a shorter setting heating time.
Safety Precautions
Before use check the cord of internal he-
ating is not faulty or twisted, if so, do
not use the appliance and provide its re-
pair at a service centre. Check often the
appliance status.
In compliance with the WEEE directive
Read the instructions
If you recognize a condition listed be-
15