Tipro FREE+ Getting Started

connect the USB controller
to the PC
you can also connect up to
and an external
FREE module if
present
Note: USB A are active if USB B is connected
SEC KBD is active if PS/2+RS232 is connected
jumper status for advanced interface settings
2
2 other USB devices
Getting started
with
FREE+
pull out for RS232 Touch
pull out for PS/2 & RS232 Controller
pull out for analog Audio
guide the cables through
the main cable channel
put back the cable cover
and fix the 6 screws
connect the power supply
provide sufficient
airflow around the
power supply *
then VGA
*operating ambient temperature range is 0°C to 40°C
3
if the cables exit at
the back remove the
back part of the
cable cover
close the connection
cover and secure it by
pressing both snaps!
WARNING:
This is a Class A product. In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures.
1
remove the
cable cover
open
the connection
cover
4
Before using
your FREE+,
set the
resolution of
your Video card
to 1024×768
and the refresh
rate to 60Hz!