Page 1
QUICK START GUIDE UVP36 WARNING! POSSIBLE RISK OF INJURY TO EYES AND SKIN. • Hazardous optical radiation may be emitted from the light source. Do not look at an operating lamp. It may be harmful to the eyes. • UVC is emitted from the light source. Eye or skin irritation may result from exposure.
Page 2
Thank you for purchasing a GOLDENSEA UV product. This manual is a quick operation guide to get you started. For more information, please always refer to the full version user manual provided. Before unpacking, please check and be sure that the package is in good condition with no damage on the carton during transportation.
Page 3
• For safety reasons, the device was designed with a motion sensor: if the working device detects any movement within 3m, it will immediately deactive and a continuous audible dual beep and flashing red and green LED indicator lights will engage. •...
Thank you for purchasing a GOLDENSEA UV product. You have acquired a powerful and versatile device. We are confident that you will be satisfied with our excellent products and service. For your own safety, please read this user manual carefully before installing and operating the device.
Page 7
www.goldenseauv.com Voltage Input: AC 100-120V~, 50/60Hz; AC 220-240V~, 50/60Hz Power: 45W; Product Size: 165x165x451mm This device is for household use, applications such as kitchen, bedroom, study, living room, etc.. It shall only be used by adults who are capable of operating this device by following this user manual, and keep children, pets and plants away from the disinfection area before operating.
www.goldenseauv.com 1. Manual Operation (control panel) 1) Close all the doors and windows. 2) Plug-in and power on, unlock the product by long pressing the Start touch key < > and the Lock touch key < > on the device for 3 seconds until there is a beep. 3) Select time setting <15 mins>, <30 mins>...
www.goldenseauv.com Start 3. Motion Sensor Operation (if the lamp with Motion Sensor) 1. Turn on the UV lamp, select the disinfection time and start, leave the room, after 2 minutes alarming (Di….Di…Di….), the UV lamps will switch on automatically, the motion sensor will be activated.
www.goldenseauv.com 5. Notes 1. Put the UV lamp on a height of 0cm-400cm to get the best disinfection effect. Please do not put the lamp higher than 400cm, as the Motion Sensor cannot detect perfectly. 2. The surface of the lamp should be kept clean. 3.
Page 11
www.goldenseauv.com Avertissement – RISQUE BLESSURES WARNING – RISK OF PERSONAL INJURY CORPORELLES THIS EQUIPMENT IS DESIGNED FOR CET ÉQUIPEMENT EST CONÇU POUR ÊTRE USE WITH GERMICIDAL LAMPS OR UV UTILISÉ AVEC DES LAMPES GERMICIDALES OU SOURCES AND MUST BE INSTALLED DES SOURCES UV ET DOIT ÊTRE INSTALLÉ...
www.goldenseauv.com 10. Replacing The UV Tube To maintain the sterilizing efficacy, the UV tube needs to be replaced after 9,000 hours of use. Steps: 1. Wait for UV tube to cool down (to avoid scalding) after switching off the device. 2.
www.goldenseauv.com 1. The UV tube is the core of the product, it should be replaced after 9000 hours of use to maintain the germicidal efficacy. 2. The UV tube is defected if it flashes, please contact your local dealer or our customer service to order a new UV tube.
Need help?
Do you have a question about the UVP36 and is the answer not in the manual?
Questions and answers