Spray Arms - Bosch 9000 035918 (8406 0) Instructions For Use Manual

en

Spray arms

Lime and remnants of food in the washing
water can block the nozzles in the spray
arms and and the arm
22 23
mountings .
Inspect the nozzles in the spray arms
for blocked holes due to remnants of
food.
If necessary, pull the lower arm
upwards and lift it off.
Unscrew the upper spray arm
Clean both spray arms under running
water.
Refit the spray arms. Ensure that the
lower arm has locked into place and the
upper one is screwed tight.
Spray arms
22
Pump *
*
on applicable models
Larger remnants of food that have not
been trapped by the filters and have been
left in the water can cause a blockage in
the pump. The water is no longer pumped
out of the dishwasher and it can be seen
covering the filter.
Proceed as follows:
23 Ladle out as much water as possible.
Remove the filters
.
22
Undo the screw in the cover (Torx T 20)
and remove the cover.
Inspect the inside and remove any
obstructions that you find.
Re-insert the cover and screw down.
Re-insert the filters and screw down.
Torx T20
.
25
1